SpectraLink Corporation

Setup and Administration—NetLink e340/i640 Wireless Telephone

 

Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation

Detect dBm coverage

As you walk the perimeter, the two-line display will show the top four access points that the Wireless Telephone can contact in a code as illustrated below.

XXX1 YY XXX2 YY

XXX3 YY XXX4 YY

-dBm

XXX1 through XXX4 are the last four digits of the access points’ MAC address. The primary access point (the access point which had the strongest signal to this Wireless Telephone) displays first, followed by the three access points with the next strongest signals.

YY is the power level in dBm at which this Wireless Telephone heard the associated access point. Although shown as a positive number, YY represents negative dBm and lower numbers represent stronger signals. For example, a displayed value of 40 indicates -40dBm, and is therefore a stronger signal than a display of 50 (which indicates -50dBm). At least one access point’s reading should be stronger than -70 dBm in all areas.

Note any areas that have inadequate dBm readings.

Detect Overlap or Conflicts

Press FCN to toggle to the Site Survey function that shows the channel number of the access points. Use this information to detect overlaps or conflicts in access point signaling.

XXX1 ZZ XXX2 ZZ

XXX3 ZZ XXX4 ZZ

Chnl

XXX1 through XXX4 are the last four digits of the access points’ MAC address.

ZZ is the channel number that the access point is using.

Note any areas that have access points that are in contention for the same channel.

It is preferable that no overlaps exist anywhere in your facility. If the site survey mode indicates two APs using the same channel, then at least one other AP must be indicated at 10 dBm stronger than those APs to avoid channel conflicts.

PN: 72-1084-02-D.doc

Page 36

Page 36
Image 36
Targus I640, e340 manual Detect dBm coverage, Detect Overlap or Conflicts