Tefal HT617138 manual Blender function depending on model, Removing the blender shaft

•Connect the appliance:

-Your appliance has 5 speed levels and a turbo button. Always begin mixing or kneading at speed 1 initially, then move to speed 2, 3, 4 or 5 (Fig. 2).

-To knead thick dough, we recommend using speed 5 only.

-You can also increase the speed by pressing the turbo button (a2); We however recommend that you use it only briefly (a maximum of 30 seconds for thick dough).

•After finishing, set the speed control (a2) to “0”.

•Disconnect and press the unlock button (i) to raise the hinged arm. Then press the mixer unlock button (j) to remove the mixer from its stand.

•Then press the ejection button (a1) to remove the beaters or kneaders.

Blender function (depending on model)

•Check that the appliance is unplugged, that the speed control (a2) is set to “0” and that the beaters or kneaders have been removed from the appliance.

•Lift the panel at the back of the appliance and screw the blender shaft (l or m) anti-clockwise without forcing it until you hear a click (Fig. 6).

If you feel resistance when screwing in, this means that shaft is not correctly aligned.

You should remove it completely and screw it in again correctly.

•Connect the appliance:

-Dip the blender shaft into the preparation before starting the appliance to avoid splashing.

-Start using the speed control (a2), (Fig. 2), initially at speed 1 then 2, 3, 4, 5. Use the Turbo button (a2) if the recipe requires more power.

-Stop the appliance before removing the blender shaft from the preparation (to avoid splashing).

Removing the blender shaft:

•Stop the appliance by selecting “0”, disconnect it and unscrew the blender shaft (l or m) by turning

clockwise.

Do not use the blender shaft:

•In a container on a heat source.

•Do not use it empty or with ice cubes, to chop raw meat, dried fruit (almonds, hazelnuts, etc.).

500ml mini-chopper function (depending on model)

-Place the bowl (n1) on the stabiliser base (q).

-Fit the blade (n2) on the shaft of the bowl (n1).

-Place the food in the bowl (n1) and then fit the reducer (n3).

•Check that the appliance is unplugged, that the speed control (a2) is set to “0” and that the beaters or kneaders are no longer on the appliance.

-Lift the panel at the back of the appliance and place the appliance on the reducer (n3) of the mini-

86