Removal and Installation Procedures
6Ć30 MTG100 & MTG300 MPEG Generator Service Manual
. Read Replacing the Hard Disk Drive(s) on page 6-71, before performing
the following procedures.
1. Assemble equipment and locate modules to be removed:
a. You need a screwdriver with a size Phillips #2 tip (Items 1 and 3).
b. Locate the modules to be removed in the locator diagram Internal
modules, Figure 6-3, page 6-14.
2. Orient instrument: Set the MPEG generator so its left side is down on the
work surface and its bottom is facing you.
3. Remove the bottom plate: Remove the four screws securing the bottom plate
to the chassis.
4. Remove the system hard disk drive: See Figure 6-14.
a. Remove the A10 Main Board as described on page 6-37.
b. Remove the A40 MISC (Power Distribution & Interface) board as
described on page 6-39.
c. Remove the clear plastic shield beneath the A40 circuit board.
d. Unplug the cables from the solid state disk and J050 on the A40 MISC
(Power Distribution & Interface) board.
e. Remove the four screws securing the system hard disk drive to the
chassis.
f. Lift the system hard disk drive away from the chassis.
5. Reinstallation: Perform steps 3 and 4 in reverse order to reinstall the system
hard disk drive.
System Hard Disk Drive