Tektronix MTG100, MTG300 List of Modules General Instructions, Summary of Procedures

Removal and Installation Procedures
6Ć10 MTG100 & MTG300 MPEG Generator Service Manual
Section 10 lists all modules.
. Read these general instructions before removing a module.
First read over the Summary of Procedures that follows to understand how the
procedures are grouped. Then read Equipment Required for a list of the tools
needed to remove and install modules in the MPEG generator.
If you are removing a module for service, begin by performing the procedure
Access Procedure (page 6-17). By following the instructions in that procedure,
you remove the module to be serviced while removing the minimum number of
additional modules.
The procedures are described in the order in which they appear in this section. In
addition, you can look up any procedure for removal and reinstallation of any
module in the Table of Contents of this manual.
The Access Procedure on page 6-17 first directs you to the procedure(s) (if
any) that are required to access the module to be serviced, then it directs you
to the procedure to remove that module.
Table6Ć4: Summary of procedures
Procedure Module Page
Procedures for
External Modules
Line cord
Cabinet
FrontĆpanel unit
FrontĆpanel assembly
6Ć18
Procedures for
Internal Modules
Fan
Floppy disk drive
Data hard disk drive
System hard disk drive
Display module
Power supply unit
6Ć25
Procedures for Board
Modules and CPU Unit
A10 Main board
A40 MISC (Power
Distribution & Interface
board)
CPU unit 6Ć37
Procedures for
Rear Panel Modules
BNC cable assembly
ECL/TTL/LVDSOUT
connector
BNC connector
ECL CONTROL
connector
6Ć44
List of Modules
General Instructions
Summary of Procedures