Removal and Installation Procedures
MTG100 & MTG300 MPEG Generator Service Manual
3. Remove the A35 Power Switch: See Figure 6-9.
a. Using a screwdriver with a size #2 Phillips tip, remove the screw
securing the A35 board to the front cover.
b. Unplug the cable from the A30 Front Panel board.
c. Lift the board away.
4. Remove the rotary encoder: See Figure 6-9. Using the 12 mm nut driver
(Item 9), remove the nut securing the rotary encoder to the front cover.
5. Remove the subpanel: See Figure 6-9. Using a screwdriver with a size #2
Phillips tip, remove the two screws securing the sub panel to the front cover.
6. Now hand disassemble the front-panel assembly components using
Figure 6-9 as a guide. Reverse the procedure to reassemble.
7. Reinstallation: Perform steps 2 through 6 in reverse order to reinstall the
front-panel assembly.