Removal and Installation Procedures
6Ć26 MTG100 & MTG300 MPEG Generator Service Manual
Figure 6Ć10: Fan removal
1. Assemble equipment and locate modules to be removed:
a. You need a screwdriver with a size #1 and a size #2Phillips tips (Items
1, 2, and 3).
b. Locate the module to be removed in the locator diagram Internal
modules, Figure 6-3, page 6-14.
2. Orient the instrument: Set the MPEG generator so its bottom is down on the
work surface and its front is facing you.
3. Remove floppy disk drive: See Figure 6-11.
a. Remove the A10 Main board as described on page 6-37.
b. Unplug the flat cable at J280 on the A40 board.
c. Using a screwdriver with a size #2 Phillips tip, remove the two screws
securing the floppy disk drive support to the chassis.
d. Using a screwdriver with a size #1 Phillips tip, remove the two screws
securing the floppy disk drive to the top of the chassis.
e. Using a screwdriver with a size #2 Phillips tip, remove the two screws
securing the floppy disk drive to the left side of the chassis.
Floppy Disk Drive