Replacing the Hard Disk Drive(s)
MTG100 & MTG300 MPEG Generator Service Manual 6Ć73
If you use the hard disk drives other than above, set the jumpers to obtain the
following configuration:
SCSI ID : 0
Terminator Power Supply : Off
Auto Spin Up : Off
Internal SCSI Terminator : Off
Auto Start Delay : Off
After you have installed the data hard disk drives properly, perform the following
procedure to format the data hard disks:
1. Select Service... from the Utility pull-down menu of the MPEG generator.
This will open the Enter Password: dialog box.
2. In this dialog box, enter “3341344803”, and then press the OK bezel button.
This will open the Service dialog box.
3. Press the TS Drive... bezel button, and then press the Quick Format bezel
button to format the disk drive. This will open the confirmation dialog box.
Press the OK bezel button to execute the operation.
During the operation, the message “Executing... xx %” will appear.
4. Press the Previous bezel button, and then press the Exit bezel button to exit
the Service menu.
Perform the following procedure to reinstall the factory-supplied files (test40.trp,
test64.trp, sample1.trp, sample2.trp, and insert.eit) on the data hard disks:
1. Insert the Maintenance CD-R into the CD-ROM drive on the PC.
2. Using the file transfer command (PC to MTG...) of the MTG Comm+
application, download the following four files to /main/usr/ts directory in
the MPEG generator:
test40.trp
test64.trp
sample1.trp
sample2.trp
Formatting the Data Hard
Disks
Reinstalling theFactoryĆsupplied Files