Texas Instruments MSP430 manual FN0016/ BlowFuse, FN0017/ SetVcc, FN0018/ ReadOutData

PRGS430.DLL—Description

Note: Use PGM_ERASE_INFO only together with the PGM_WITH_ERASE flag.

lpszProjectIni

Name of the {project}.ini file, if protection settings from this file are used. If no protection is required, replace lpszProjectIni with NULL.

The added features do not need to be used—for ProgramFile according to older specification, just call ProgramFile(FileName, FileType, 0, NULL); if no {project}.ini file or erase check is used, just call:

Example: lFuncReturn = ProgramFile(FileName, 0, 0, NULL); // with autodetect file type

Note: If an erase or erase-check function reports an error, the function ProgramFile() is aborted before programming is started.

/FN0016/ BlowFuse

long int BlowFuse(void)

This function blows the security fuse of the target device.

Example: lFuncReturn = BlowFuse(void)

/FN0017/ SetVcc

long int SetVcc(long int iVoltage)

This function sets the VCC_MSP voltage of the programming adapter to the given value.

iVoltage: VCC in mV. (3000 −> 3 V)

The correct MSP430 device should be selected before using this function.

The voltage range is limited to the voltage range allowed for the selected MSP430 device.

Example: lFuncReturn = SetVcc(Long:3000)

/FN0018/ ReadOutData

long int ReadOutData(long int wStart, long int wLength, void* lpBuffer)

Reads out data from the device and writes it to the buffer passed

wStart: Start address of the area to be read out. Allowed values : 0x0000−0xFFFE (see memory map for the corresponding device)

wLength: Length of the area. Allowed values : 0x0000−0xFFFE (see memory map for the corresponding device)

lpBuffer: Pointer points to a buffer that receives the data. The buffer must be large enough to hold the entire data; otherwise, a fatal error of the operating system may occur.

Operation 2-19