Tiger Products Co., Ltd 5083E, 5093E, 5101E manual Regular Maintenance, Daily or Every 8 Hours

MAINTENANCE

MAINTENANCE

Regular Maintenance

The intervals at which regular servicing should be done are based on hours of operation. Use the tractors hour meter to determine when regular servicing is required.

Refer to the Detailed Maintenance section for futher instructions on greasing. Copy and use the Daily Maintenance sheet located at the end of this section.

Daily or Every 8 Hours

	ITEM	SERVICE	COMMENTS
	Drive Shaft Yoke, U-Joint	Grease	Grease as instructed in
	& Stub Shaft		detailed maint. section
	Pump Drive Shaft Coupler	Check and Lube	Insure drive shaft end play
	Crankshaft Adapter	Check rubber grommets	Replace grommets if
			damaged or missing
Pivot Points		Lubricate	Inject grease until it
			appears at end
Hydraulic Fittings		Check for leaks	Tighten when needed. Do Not use hands
			to check for leaks, see maint. Precautions
	Knives	Check	Inspect for missing or damaged knives,
			change as needed.
	Spindle mouting bolts	Check	Torque to 331ft. lbs. lubricated
	spindle to deck)		Torque to 357ft. lbs. dry
	Knife mounting bolts	Check	Pre-lubricate threads, then
	(knife to disk or blade bar)		torque to 800 ft. lbs.
	Disk/Blade Bar mounting bolts	Check	Torque to 184ft. lbs. lubricated
	(disk/blade bar to spindle)		Torque to 180ft. lbs. dry
	Belts	Check/Adjust	Check if broken, tighten as required
	Main Frame and	Check	Retorque bolts to torque
	Deck		specifications in this section
	Hydraulic Fluid Level	Check	Add if required per fluid recommendations
	Rear Flail Drive(if applicable)	Lubricate	Grease as instructed in
	Bear Flange and Shaft Coupler		detailed maint. section
	Cutter Shaft and	Lubricate	Grease as instructed in
	Ground Roller		detailed maint. section
	Boom	Maintenance Section 4-4
	©2011 Alamo Group Inc.