Tiger Products Co., Ltd 5101E, 5083E Troubleshooting, Maintenance, Vibration, Mower will not lift

MAINTENANCE

MAINTENANCE

TROUBLESHOOTING

SYMPTOMS	CAUSE		REMEDY
Vibration	1.	Loose Bolts	1. Check all bolts and tighten to
				recommended torque specs.
	2.	Cutter assembly	2a. Check for damage blades, disc
		Unbalanced		or cutter shaft. Replace if needed.
			2b. Check for wire, rope, etc.
				entangled in the cutter assembly
Mower will not lift	1.	Hyd. Fluid Low	1. Check and refill Hyd Fluid
	2.	Leaks in line ROU	2. Tighten or replace fittings and hoses
	3.	Faulty relief valve	3. Check pressure in line. Line
				pressure in Control Valve should be
				at least 2500 P.S.I.
	5.	Faulty cylinder	5.	Inspect, repair or replace cylinder
Mower will not start	1.	Blown fuse	1.	Check fuse between mower switch
or run				and ignition/replace
	2.	Ball valves closed	2. Make sure valves are open
	3.	Low oil level	3. Check Hyd. tank and fill
	4.	Line leak	4.	Check all fittings and lines,
				re-tighten or replace
	5.	Electronic	5a.	Without the tractor running, turn
		solenoid faulty		the mower switch to on. A low
				audible click should be heard if the
				solenoid is engaging the solenoid
				spool. If click is not heard, leave
				switch in on position and with a
				screwdriver or other steel object,
				touch the small nut on the end of the
				solenoid. If the metallic object is not
				attracted to the nut, check the fuse
				and wiring for an open circuit. If the
				object is attracted but no “click” is
				heard, replace the solenoid.
			5b. Remove the four bolts holding the
				small block to the main block. Lift
				and remove small block being
				careful not to damage O-rings/filter.
				Clean filter and re-install.
			5c. Remove large nut on side of large
				valve block. Remove spring, and use
				needle nose vise grip to pull spool from
				block. Check block and spool
				for contaminates and scratches.
				Clean parts or replace if scratched.
Boom		Maintenance Section 4-6
©2011 Alamo Group Inc.