Tiger Products Co., Ltd 5083E, 5093E, 5101E Troubleshooting Continued, Maintenance, Motor runs but

MAINTENANCE

TROUBLESHOOTING (CONTINUED)

SYMPTOMS	CAUSE		REMEDY
Motor runs but	1.	Belts	1.	Inspect belts and pulleys. Replace
will not cut.				belts and repair as needed.
	2.	Tensioner	2.	Adjust tensioner nut flat washer
				washer is flush with top of guide.
Mower turns slowly	1.	Contaminants	1.	Remove large nut on side of large
or not at all.		restricting spool		valve block. Remove spring, and use
		movement in		needle nose vise grip to pull spool
		valve body.		from block. Check block and spool
				for contaminates and scratches.
				Clean parts or replace if scratched.
	2.	Suction lines	2.	Check for kinkes or obstruction in
		obstructed		suction hose.
	3.	Low oil level	3.	Check Hyd. tank level and fill.
Pump will not work	1.	Excessive wear	1.	Disassemble and repair.
		on internal parts
Motor will not work	1.	Excessive wear	1.	Disassemble and repair.
		on internal parts

NOTE: If flow meter is available, check pressure and flow volume for all suspected hydraulic problems.

If the solution to your problem cannot be found in this section, call the Technical Service representative at the number shown on the front cover of this manual.

Boom Maintenance Section 4-7

©2011 Alamo Group Inc.

MAINTENANCE