Tiger Products Co., Ltd 5101E 50” FLAIL KNIFE BLADE REPLACEMENT, 63” BOOM FLAIL KNIFE REPLACEMENT

MAINTENANCE

MAINTENANCE

50” FLAIL KNIFE BLADE REPLACEMENT

1.If knives are damaged or badly worn, they will need to be replaced as a set. Replacing a single knife can cause severe knife can cause severe vibration and possible damage to the mower. The knife should not be welded on for any reason.

2.Always replace the knife bolts when replacing the knives. DO NOT REUSE THE KNIFE BOLTS OR NUTS.

3.Assemble knives, bushings, bolts and nuts as shown in part section of the manual.

4.Install the locking hex nut so that the flat face of the nut is towards the knife.

5.Apply loctite “271” or equivalent to threads.

6.Torque nut to 50 ft. lbs. Knife must swing freely.

DO NOT re-use the locking hex nuts for mounting the knives. If hex nut becomes loose, or required removal for knife replacement or any other reason, they must be discarded and replaced with new nuts.

63” BOOM FLAIL KNIFE REPLACEMENT

1.If knives are damaged or badly worn, they will need to be replaced as a set. Replacing a single knife can cause severe vibration and possible damage to the mower.

2.Assemble knives, clevis, bolts and nuts as shown in part section of manual.

3.Install locking hex nut so that the flat face of nut is towards the knife.

4.Apply loctite “271” or equivalent to threads.

5.Torque nut to 35 FT. LBS. Knife must swing freely.

DO NOT re-use the locking hex nuts for mounting the knives. If hex nut become loose, or require removal for knife replacement or any other reason, they must be discarded and replaced with new nuts.

Knives should not be welded on for any reason.

HEAVY DUTY SPINDLE ASSEMBLY INSTALLATION AND BEARING ADJUSTMENT

WARNING! A press MUST be used to install bearing cups, bearing cones, and seals. DO NOT use a hammer to install races, bearings, or seals. The parts of assembly may be damaged.

NOTE: The grease zerk and gussets are located on the top side of the spindle housing. Be sure the spindle is assembled correctly.

Be sure to wear eye protection and other protective equipment as needed when working on spindle assembly.

Boom Maintenance Section 4-24

©2011 Alamo Group Inc.