Toshiba 51HX94 owner manual Manually adding and deleting channels in the channel memory

Chapter 6: Setting up your TV

Programming channels into the TV’s channel memory (continued)

Manually adding and deleting channels in the channel memory

After you have programmed the channels automatically, you can manually add or delete individual channels in the channel memory.

To add or delete channels in the channel memory:

1.Press MENU and open the SETUP menu.

2.Highlight INSTALLATION and press ENTER. (A new set of INSTALLATION menu icons will appear on-screen, as shown in step 3).

Setup

Installation
Sleep Timer
On/Off Timer
HDMI Audio Selection				Auto
Side Show Interval			2 Sec
AVHD Skip Time			15 min
Convergence
				DVD RTN
	Navigate	Select			Back	EXIT	Exit
				CH RTN

3.Open the TERRESTRIAL menu, highlight CHANNEL ADD/DELETE, and then press ENTER.

Note: If you have a cable box connected to ANT 1 during TV Guide On Screen setup, the TERRESTRIAL menu will not be accessible and you must then use the TV Guide

On Screen channel editor to add/delete channels.

Terrestrial

Input Configuration

Channel program

Channel Add/Delete

Signal Meter

Navigate	Select	DVD RTN	Back	EXIT	Exit
		CH RTN

4.The illustration below shows channels programmed for the ANT 1 antenna input. To view the list of channels programmed for the ANT 2 antenna input, highlight CHANGE ANTENNA and press ENTER.

Channel Add/Delete

Channel	Signal	Antenna
2	Analog	1
3	Analog	1
4	Analog	1
5	Analog	1	Change Antenna
6	Analog	1	Clear All
7	Analog	1	Save
8	Analog	1

Cancel

To add a channel to the channel memory:

Highlight the unchecked box next to the channel number you want to add, and then press ENTER to check the box.

To manually add digital subchannels on a physical channel:

Use the Channel Numbers and the Dash (–/100) on the remote control to enter the channel number (for example, 56–1).

If the channel is found, the number will be added to the list and the box will be checked.

If the channel is not found, a message will appear.

To remove a channel from the channel memory:

Highlight the checked box next to the channel number you want to remove, and then press ENTER to uncheck the box.

To save your new settings:

Highlight SAVE and press ENTER.

To revert to your original settings:

Highlight CANCEL and press ENTER before saving.

To remove all channels from the channel memory:

Highlight CLEAR ALL and press ENTER, and then highlight SAVE and press ENTER.

Note:

•This action applies to the current antenna input only. To delete/add channels on the other input, highlight CHANGE ANTENNA and press ENTER.

•This action cannot be cancelled unless you highlight CANCEL and press ENTER before saving your changes.

Channel Add/Delete

Channel	Signal	Antenna
2	Analog	1
3	Analog	1
4	Analog	1
5	Analog	1	Change Antenna
6	Analog	1	Clear All
7	Analog	1	Save
8	Analog	1

Cancel

42 Copyright © 2004 TOSHIBA CORPORATION. All rights reserved.

51,57HX94(E)040-43 42 9/12/04, 7:09 PM