Toshiba 51HX94 Adjusting the color convergence, Manually adjusting the color, Convergence

Chapter 6: Setting up your TV

Adjusting the color convergence

This projection TV uses three separate image tubes: red, green,

Manually adjusting the color

and blue. The red, green, and blue images are projected onto the

convergence

screen where they converge to form a full-color picture. You can

see a clear picture only when the three images converge correctly.

To check and adjust the color convergence manually:

Convergence may drift over time or if you move the TV. If you

1. Press MENU and open the SETUP menu.

can see clear images on your TV screen, skip this procedure.

2. Highlight CONVERGENCE and press ENTER.

This adjustment should be made only after the TV has been on

for at least 30 minutes.

Automatically adjusting the color

Setup

Sleep Timer

Installation

convergence using TouchFocus

®

On/Off Timer

2 Sec

Side Show Interval

HDMI Audio Selection

Auto

AVHD Skip Time

15 min

To automatically adjust the color convergence:

Convergence

DVD RTN

Navigate

Select

Back

EXIT

Exit

Press TouchFocus on the TV front panel one time.

CH RTN

3. When the convergence screen appears, press ENTER.

TV front panel

The TV will enter auto-convergence mode. When the

adjustment is complete, the TV will enter 56-point

convergence mode automatically.

MENU VOLUMECHANNEL EXIT TV/VIDEO TouchFocus

cursor

TouchFocus

The TV will enter the auto convergence mode.

: TO SELECT POS I T I ON

ENTER : TO ADJUST CONVERGENCE

EX I T : TO F I N I SH ADJUSTMENT

Horizontal

TOUCH FOCUS

	B	R	G		If you see separate red, blue, or green crossed lines (or red
					or blue shadows next to white lines), you need to adjust the
					convergence.
			Vertical	4.	Press yzx • to move the cursor to the position you want
					to adjust.
TOUCH FOCUS F I N I SHED				5.	Press ENTER repeatedly to select RED or BLUE adjusting
					mode (red crossed lines or blue crossed lines), depending on
					which color needs adjusting.
When adjustment is complete, the normal picture will				6.	Press y (up), z (down), x (left), or • (right) on the remote
					control to converge the red or blue line into the white line.
reappear.

You can adjust the convergence manually described at right for more detailed convergence adjustment.

: TO ADJUST RED

ENTER : TO CHANGE COLOR

EX I T : TO F I N I SH ADJUSTMENT

: TO ADJUST BLUE

ENTER : TO SELECT POS I T I ON

EX I T : TO F I N I SH ADJUSTMENT

Copyright © 2004 TOSHIBA CORPORATION. All rights reserved. 49

51,57HX94(E)044-52 49 9/12/04, 7:11 PM