Toshiba 51HX94 owner manual Labeling the video input sources, To label the video input sources

Chapter 8: Using the TV’s features

Labeling the video input sources

You can label each video input source according to the type of device you connected to each source, from the following preset list of labels:

ÐÐ (default label)

Hide (to hide an unused input in the Input Selection window)

Audio Receiver

VCR

Video Recorder

Laser Disk

Compact Disc

DVD

DTV

SAT (satellite box)

CBL (cable box)

HD (high definition device)

PVR (personal video recorder)

Note:

•If you set up devices in TheaterNet,™ the associated inputs are automatically labeled and cannot be relabeled until you remove the device from TheaterNet (see page 44).

•If you set up a cable box in VIDEO 1, it will automatically be labeled and cannot be relabeled until you remove the device from the TV Guide On Screen setup.

•You cannot select IEEE-1394 devices through the INPUT SELECTION window; however, you can select and control IEEE-1394 devices through TheaterNet (see page 44).

To label the video input sources:

1.Press MENU and open the PREFERENCES menu.

2.Highlight INPUT LABELING and press ENTER.

Preferences

Favorite Channels
Closed Caption Mode			Off
Closed Caption Advanced
Input Labeling
Menu Language		English
			DVD RTN
	Navigate	Select		Back	EXIT	Exit
			CH RTN

3.Press z or y to highlight the video source you want to label.

4.Press x or • to select the desired label for that input source. If a particular input is not used, you can select ÒHIDDENÓ as the label, which will cause

that input to be Ògrayed outÓ in the input list and skipped over when you press the INPUT button on the remote control.

5.To save the labels, highlight SAVE and press ENTER.

Note:

If you select “HIDDEN” for all of the input labels, the POP feature will be disabled. If you attempt to access the POP feature, a red “NOT AVAILABLE” will display at the bottom of the screen.

Input labeling example:

If you connect a VCR to VIDEO 1, a DVD player to ColorStream HD-1, and a high definition satellite receiver to HDMI, and then label the video input sources accordingly (as shown in step 4 at left), when you press INPUT or TV/VIDEO, the INPUT SELECTION screen would look like the screen below right:

Input Selection screen	Input Selection screen with
with no inputs labeled	inputs 1, 4, and 6 labeled,
	and input 5 hidden.

To clear the input labels:

1.Press MENU and open the PREFERENCES menu.

2.Highlight INPUT LABELING and press ENTER.

3.Highlight RESET and press ENTER.

4.Highlight SAVE and press ENTER.

Preferences

Favorite Channels
Closed Caption Mode			Off
Closed Caption Advanced
Input Labeling
Menu Language		English
			DVD RTN
	Navigate	Select		Back	EXIT	Exit
			CH RTN

Note: Labels for devices you set up in TheaterNet will not be cleared until you remove the device from TheaterNet (see page 44). The screen above right illustrates an example of the Input Labeling screen after it was reset that still shows the VCR label for VIDEO 1 because the VCR was set up in TheaterNet.

68 Copyright © 2004 TOSHIBA CORPORATION. All rights reserved.

51,57HX94(E)067-76 68 9/12/04, 10:02 PM