Toshiba 51HX94 owner manual Setting up the TV Guide On Screen system, On next

Chapter 5: TV Guide On Screen setup

Setting up the TV Guide On Screen system (continued)

Screen 5: Which TV input is your cable box plugged into? If you select ANT 1, screen 6 appears.

If you select VIDEO 1, screen 7 appears.

Screen 6: Select the channel your TV is tuned to when using your cable box, and then press ENTER. Screen 7 appears.

Screen 7: The on-screen diagram shows the correct way to connect your Cable box to the G-LINKªjack on the TV.

Make sure the G-LINK cable is installed properly. For additional details, see page 25.

Press ENTER to display screen 8.

Screen 8: Highlight your Cable box brand, and then press ENTER to display screen 9.

Screen 9: To allow the TV Guide On Screen system to find the correct code for your brand of Cable box, tune your Cable box to channel 02, leave the Cable box and TV ON, and then press ENTER. Screen 10 appears.

Screen 10: The TV Guide On Screen system will test the code for the brand of Cable box you selected. Do not press any keys on the TV, remote control, or Cable box until the testing process is completed. When testing is completed, screen 11 appears.

Screen 11: If your Cable box tuned itself to channel 09 after testing, select YES and press ENTER. If you selected ANT 1 in screen 5, screen 13 appears. If you selected VIDEO 1 in screen 5, screen 12 appears.

If your Cable box did not tune itself to channel 09 after testing and you want to test the same code again, select TEST THIS CODE AGAIN and press ENTER.

If you want to test a different code, select NO and press ENTER. Screen 10 appears.

Note: Many cable boxes require testing more than one code.

(Continued on next page)

Copyright © 2004 TOSHIBA CORPORATION. All rights reserved. 37

51,57HX94(E)036-39 37 9/12/04, 7:07 PM