Toshiba M30-35 manual IEEE1394 test program Tests and Diagnostics

3.27 IEEE1394 test program 3 Tests and Diagnostics

3.27 IEEE1394 test program

This section describes how to perform the IEEE1394 test with the test program.

NOTE: Use another computer that can communicate by IEEE1394 (i. Link) cable as a reference machine to perform this test.

Toshiba MS-DOS is required to run the DIAGNOSTICS TEST PROGRAM. To start the DIAGNOSTIC TEST PROGRAM, follow these steps:

(a)Insert the Diagnostics disk in the floppy disk drive and turn on the computer. (The Diagnostics Disk contains the MS-DOS boot files.)

The following menu will appear:

********************************************************************

* XXXXX IEEE1394[XXXXX] Diagnostics program*

********************************************************************

*	1	....Transmit & Receive test	*
*			*
*	2	....Responder set	*
*			*
*	3	....1394 GUID Display	*
*			*
*			*

********************************************************************

.... Press test number[1-3] ?

(b)To execute the TEST, select the test number you want to execute and press Enter. Subtest 01 Transmit & Receive test

This program checks the data transporting between responder machine and target machine.

Subtest 02	Responder set
	This program initializes the machine responder.
Subtest 03	1394 GUID Display
	This program checks the GUID.

Satellite M30-35 Maintenance Manual (960-455) 3-57