Under Ceiling Type | Installation Manual |
7 APPLICABLE CONTROLS
REQUIREMENT
•When you use this air conditioner for the first time, it takes approx. 5 minutes until the remote control becomes available after
<When power is turned on for the first time after installation>
It takes approx. 5 minutes until the remote control becomes available.
|
|
|
|
|
|
| Approx. 5 minutes | |||
|
|
|
|
|
|
| ||||
Power |
|
| “SETTING” |
|
| “SETTING” |
|
| Remote | |
|
|
|
|
|
| |||||
on |
|
| flashes |
|
| goes out |
|
| control is | |
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
| available |
|
|
|
|
|
|
|
|
|
|
|
<When power is turned on for the second (or later) time>
It takes approx. 1 minute until the remote control becomes available.
|
|
|
|
|
|
|
| Approx. 1 minutes | |||
|
|
|
|
|
|
|
| ||||
Power |
|
| “SETTING” |
|
| “SETTING” |
|
| Remote | ||
|
|
|
|
|
| ||||||
on |
|
|
| flashes |
|
| goes out |
|
| control is | |
|
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
| available |
|
|
|
|
|
|
|
|
|
|
|
|
•Normal settings were made as factory default. Change the indoor unit settings as required.
•Use the wired remote control to change the settings.
*The settings cannot be changed using the wireless remote control, sub remote control, or
Changing applicable control setting
Basic procedure for changing settings
Change the settings while the air conditioner is not working.
(Be sure to stop the air conditioner before making settings.)
4 | 6 | 3 | |
5 2 | |||
1 |
Procedure 1
When pushing 
, 
, and 
buttons simultaneously for 4 seconds or more, after a while, the display part flashes as shown in the figure.
Check that the displayed CODE No. is [10].
•If the CODE No. indicates other than [10], push 
button to erase the display, and then retry the operation from the first step.
(For some time after 
button has been pushed, the operation of the remote control cannot be accepted.)
(In a group control, the firstly displayed indoor UNIT No. becomes the master unit.)
(* Display content varies with
the indoor unit model.)
Procedure 2
Every pushing 
button, the indoor UNIT No. in the group control is displayed successively.
Select an indoor unit of which setup to be changed. In this time, the position of the indoor unit of which setup to be changed can be confirmed because the fan and the louver of the selected indoor unit work.
Procedure 3
Using temp. setup 
/ 
buttons, specify CODE
No. [ 
].
Procedure 4
Using timer time 
/ 
buttons, select SET DATA [ 
].
– 21 – |
