Basic setup (VCR)
Setting the video channel
When a TV is connected with the 75 ohm coaxial cable only.
To view playback of a recorded tape or DVD disc, or to watch a program selected by the VCR's channel selector, the TV must be set to channel 3 or 4 (video channel).
POWER DVD/VCR
3
4
TV/VCR
DVD/VCR SELECT
Setting the video channel
1Press DVD/VCR to operate the DVD/VCR.
2Press and hold 3 or 4 on the remote for 3 seconds in standby mode.
| The video channel will |
| |
OR | start to flash for 3 |
| |
| seconds in the display |
| |
| window. |
| |
|
|
|
|
|
|
|
|
|
|
|
|
For a
If CH 3 or 4 corresponding to the video channel cannot be tuned on your TV, proceed as follows: set the VCR 3/4 channel selector and the TV to CH 3 or 4, playback a prerecorded tape and tune the TV to receive a sharp color picture from the video cassette recorder. Refer to your TV owner's manual for details.
Note:
If the unit does not operate properly, or No key operation (by the unit and/or the remote control): Static electricity, etc.,
may affect the player's operation. Disconnect the AC power cord once, then connect it again.
Basic setup (VCR)
3Press POWER on the remote control or ON/ STANDBY on the unit to turn on the DVD/VCR.
4Press DVD/VCR SELECT to select the VCR mode.
The VCR indicator on the
front panel will light.
5Turn ON the TV and set to CH 3 or 4 to corre- spond with the channel selected in step 2.
6Press TV/VCR to select the VCR position.
The VCR indicator will appear in the display window.
7Select any channel to receive a TV station in your area.
The channel number will appear on the screen for about 4 seconds.
27
27 | 21/3/06, 9:42 AM |