zUniversal Repeater - In Repeater mode, the AP with WDS enabled will relays data to an associated root AP. AP function is enabled meanwhile. The wireless repeater relays signal between its stations and the root AP for greater wireless range.
zWDS Repeater - In Universal Repeater mode, the AP with WDS disabled will relays data to an associated root AP. AP function is enabled meanwhile. The wireless repeater relays signal between its stations and the root AP for greater wireless range.
¾Wireless Name of Root AP - If you select the radio button before Wireless Name of Root AP, the AP client will connect to the AP according to SSID. Enter the SSID of AP that you want to access.
¾MAC Address of Root AP - If you select the radio button before MAC Address of Root AP, the AP client will connect to the AP according MAC address. Enter the MAC address of AP that you want to access.
¾Region – Please select the right region from the drop-down list.
¾Channel Width - Determines the channel width to be used. It is unnecessary to change the default value unless required.
¾Enable Wireless Radio - Select or deselect this check box to allow or deny wireless stations to access the device.
Click the Survey button to detect the SSIDs in the local area.
)Note:
To apply any settings you have altered on the page, please click the Save button, and then you will be reminded to reboot the device.
2)Access Point: This mode allows wireless stations to access this device.
Figure
¾SSID (Set Service Identifier) - Identifies your wireless network name. Create a name up to 32 characters and make sure all wireless points in the wireless network with the same SSID. The default SSID is
24
