Trane PKGP-PRC003-EN manual Jobsite Connections, Zone Sensors -TypicalNumber Of Wires

Models: PKGP-PRC003-EN

1 56
Download 56 pages 28.86 Kb
Page 44
Image 44
Jobsite Connections

Jobsite Connections

DISCONNECT

SWITCH

(BYOTHERS)

ZONESENSOR

ROOFTOP

UNIT

Zone Sensors —Typical Number Of Wires

 

A— Manual Changeover

6

Manual/Auto Changeover

7

Manual/Auto Changeover with

 

Status Indication LED’s

10

Programmable Night Setback with

 

Status Indication LED’s

7

B— 3 Power Wires + 1 Ground Wire (three phase) 2 Power Wires + 1 Ground Wire (single phase)

For specific wiring information, see the installation instructions. All wiring except power wires is low voltage.

All customer supplied wiring to be copper and must conform to NEC or CEC and local electrical codes. Wiring shown dotted is to be furnished and installed by the customer.

44

PKGP-PRC003-EN

Page 44
Image 44
Trane PKGP-PRC003-EN manual Jobsite Connections, Zone Sensors -TypicalNumber Of Wires

FAQ

What are the typical number of wires for zone sensors?

A Manual Changeover requires 6 wires, Manual/Auto Changeover requires 7 wires, and Manual/Auto Changeover with Status Indication LEDs requires 10 wires.

What type of wiring is required for the Heat Pump?

All wiring except power wires is low voltage. Customer supplied wiring must be copper and conform to NEC or CEC and local electrical codes.

Where can I find specific wiring information?

Specific wiring information can be found in the installation instructions for the Trane Heat Pump PKGP-PRC003-EN.