Trane Tracer, ZN510 Controller manual Zone Sensor Features Fan Switch Optional, Communication Jack

Zone Sensor

Zone Sensor Features

Fan Switch (Optional)

The zone sensor fan switch provides the controller with an occupied (and occupied standby) fan request signal of OFF or AUTO. If the fan control request is communicated to the controller, the controller ignores the hardwired fan switch input and uses the communicated value. The zone sensor fan switch signal can be enabled or disabled through configuration in the ZN510 controller.

ON or CANCEL Buttons

Momentarily pressing the ON button

Table 6: Zone Sensor Options

during unoccupied mode places the controller in occupied bypass mode for 120 minutes. You can adjust the number of minutes in the unit controller configuration using Trane’s service tool, Rover. The controller remains in occupied standby mode until the override timer expires or until the CANCEL button is pressed.

Communication Jack

Use the RJ-11 communication jack as the connection point from Rover to the communication link (when the communication jack is wired to the communication link at the

controller). By accessing the communication jack via Rover, entrance to all controllers on the link may be gained.

Part Number:

X13510628010

Description:

zSpace temperature (0.2 C resolution).

zInternal setpoint.

zCommunication jack.

zVertical case with Trane logo

	RT1			ZONE	1
	10K OHM @
	25 °C ± 2°C			SIGNAL (COMMON)	2
	R7 1K	VR1	200	CSP
					3
ADJ USTABLE
SETPOINT				COMM HIGH (+ )	4
				COMM LOW (-)	5
MJ1	COMMUNICATIONS
	JACK

Part Number:

X13510606010

Description:

zSpace temperature (0.2 C resolution).

zExternal setpoint.

zCommunication jack.

zVertical case with Trane logo

	RT1			ZONE	1
	10K OHM @
	25 °C ± 2°C			SIGNAL (COMMON)	2
	R7 1K	VR1	200	CSP
					3
ADJUSTABLE
SETPOINT				COMM HIGH (+ )	4
				COMM LOW (-)	5
MJ1	COMMUNICATIONS
	JACK

16