Trane Tracer manual Troubleshooting, Red Service LED, Green Status LED, Yellow Service LED

Troubleshooting

Red Service LED

Table 9: Red LED activity

Red LED Activity

Description

LED off continuously when power is applied to the	Normal operation.
controller.
LED on continuously, even when power is applied to	Someone is pressing the service button or the controller has
the controller.	failed.
LED flashes once every second.	Use Rover, Trane’s service tool, to restore the unit to normal
	operation or unconfigured.

!Warning! Service Button

The black Service button on the ZN510 board allows the user to send a service pin message, which allows efficient identification of the unit's location. However, if the Service button is held for more than 10 seconds, the ZN510 will shut down the software application and disable the unit's operation. The only method to restore the unit is through the use of Rover service tool. We strongly suggest that this function only be exercised under the strict direction of factory service personnel.

Green Status LED

The green LED normally indicates whether the controller is powered on (24 VAC).

Yellow Service LED

Table 11: Yellow LED activity

Table 10: Green LED activity

Green LED Activity	Description
LED on continuously.	Power on (normal operation).
LED blinks (one blink).	Manual output test mode (2-second hold), No
	diagnostics present.
LED blinks (two blinks).	Manual output test mode (2-second hold),
	One or more diagnostics are present.
	“Wink” mode.
	This feature allows the identification of a
	controller. By sending a request from a device,
	such as Rover, Trane’s service tool or ZN510
LED blinks (1/4 second on,	Loop Controller, a request to the controller
1/4 second off for 10 seconds.	can be made to “wink” a notification that the
	controller received the signal. When the zone
	sensor ON button is held for 10 seconds
	“Wink” mode is sent from Comfort Link
	Controller.
	z Power off.
LED off.	z Abnormal condition.
	z Test button is pressed.

Yellow LED Activity

Description

LED off continuously.	The controller is not detecting any communication.
	(Normal for standalone applications).
LED blinks.	The controller detects communication. (normal for
	communicating applications, including data sharing).
LED on continuously.	Abnormal condition.

22