Trango Broadband M2400S Set apid apid 00-FF in HEX, Opmode on y, Set defaultopmode on or off

Basic Configuration via CLI

	AP SYSTEM INFORMATION PARAMETERS AND RELATED COMMANDS
AP Parameter		Description	Related CLI Command
AP ID		This parameter provides a	set apid <apid> (00-FF in HEX)
		unique number for each AP. If
		Target AP is specified on SU,	Example:
		the SU can only authenticate	#>set apid 33
		with the specified AP. The
		default AP ID is the last two
		bytes of the MAC address.
Opmode		Current Opmode of the radio.	opmode on y
			This sets the radio to Opmode “ON.” If the radio is
			accessed via the Ethernet port within the first 30
			seconds after reboot/power cycle, the Opmode will
			default to “OFF.”
Default Opmode		Determines the Opmode (“ON”	set defaultopmode <on or off>
		or “OFF”) of the radio after	Example:
		reboot/power cycle. When this
		parameter is set to “ON,” the	#>set defaultopmode on
		radio will progress into
		Opmode “ON” automatically
		after a reboot/power cycle.
Opmode Start		Determines the amount of time	set defaultopmode on [<time (sec)>]
		the radio will remain in	Example:
		Opmode “OFF” after
		reboot/power cycle before	#>set defaultopmode on 60
		progressing to the default
		Opmode.
IP		IP, Subnet, and Gateway	ipconfig [<new ip> <new subnet mask> <new
Subnet		address of the radio.	gateway>]
Gateway			Example:
			#>ipconfig 10.1.1.2 255.0.0.0 10.1.1.1
TFTPD Status		TFTPD status (on or off).	tftpd [<onoff>]
		TFTPD should be turned on to	Example:
		import a file into the radio	#>tftpd on
		(such as new firmware).
		Default is off. TFTPD will
		revert to Off after rebooting.

Trango Broadband Wireless — User Manual M2400S Rev A Page 22