Trango Broadband M2400S Mirth 0..3, Mbps, Freq ch# vh, Antenna vhe, Rfrxth, Power set minmaxdBm

Basic Configuration via CLI

AP SYSTEM INFORMATION PARAMETERS AND RELATED COMMANDS

AP Parameter	Description	Related CLI Command
MIR Threshold (Kbps)	User specified MIR Threshold.	mirth [<0..3, Mbps>]
	To specify total throughput	Example:
	level that the AP will serve only
	CIR (committed information	#>mirth 2
	rate) to associated SUs.
	When MIR Threshold is
	disabled, the AP will serve MIR
	for all its SUs.
	When MIR Threshold is
	activated, and the network
	traffic exceeds the MIR
	Threshold, the AP will only
	serve CIR for all its SUs.
	When MIR Threshold is
	activated, and the network
	traffic does NOT exceed the
	MIR Threshold, the AP will
	still serve MIR for all its SUs.
Active Channel	Current RF channel	freq [<ch#> <vh>]
		Example:
		#>freq 3
		This command will change the channel of the AP to
		3.
Antenna	Current antenna selection:	antenna [<vhe>]
	(h)horizontal, (v)vertical,
	(e)external
RF RX Threshold	Specifies the receiver	rfrxth <-90-85-80-75-70-65>
	sensitivity of the AP. It is a	example:
	powerful tool when the radio is	#>rfrxth –70
	in a noisy environment. AP
	will block out any signal
	received which is below the RF
	Rx threshold. Separate settings
	exist for both ISM and UNII
	bands.
RF TX Power	Current transmit power of the	power <set> <minmax<dBm>
	AP not including antenna gain.	Example:
		#>power set 10
Channel Table	Assigned frequencies to	freq writechannel [<ch#> <freq>]
	channels. All channels may be	Example:
	re-assigned as desired by the	#>freg writechannel 3 910
	administrator.	This command will change channel 3 to 910 Mhz.
Broadcast Packet Filter	This software switch (0)	sw 0 [<onoff>] (default is on)
	enables/disables the blocking of	Example:
	Ethernet control packets, except	#>sw 0 on
	ICMP and ARP, to reduce the	note: All switch settings (0-7) are set using the sw #
	amount of unnecessary
	overhead introduced to the	[<on/off>] command.
	wireless link.
SU to SU	This software switch (3)	sw 3 [<onoff>] (default is off)
	enables/disables the SU to SU	Example:
	feature. When SU to SU is	#>sw 3 on
	turned on, multiple SU’s within
Trango Broadband Wireless — User Manual M2400S Rev A		Page 23