TRENDnet TEW-P1U, TEW-P1P manual Windows 95/98/Me/NT/2000/XP Troubleshooting, Select Control Panel

are damaged. In addition, check the cable connection. If the pins are damaged, contact your dealer for a replacement connector.

Windows 95/98/Me/NT/2000/XP Troubleshooting

Multi-Segment LAN Environment Installation (through the Network Print Port)

If your print server and Windows 95/98/Me/NT/2000/XP are located on two different segments, and your Windows NT server is used as the router/gateway you will need to implement the following procedures in order for your print server to function properly:

Add the RIP for NWLink IPX/SPX compatible transport. See RIP for NWLink IPX/SPX compatible transport Installation Procedure later in this section.

Add the frame type 802.2 for both Ethernet adapters. See Multi-Segment Frame Type

802.2Installation later in this section.

RIP for NWLink IPX/SPX compatible transport Installation Procedure

1.From your Windows NT server that is used as a router, select Start from the bottom left hand corner of the screen.

2.Select Settings.

3.Select Control Panel.

4.Double-click the Network icon.

5.Select Services.

6.Select Add.

7.In the Select Network Service box, select the RIP for NWLink IPX/SPX compatible transport. Click OK.

8.Follows the directions on the screen.

9.Done!

Multi-Segment Frame Type 802.2 Installation

1.From your Windows NT server that is used as a router, select Start from the bottom left hand corner of the screen.

2.Point to Settings, and select Control Panel.

3.Double-click the Network icon.

4.Select Protocols. Select the NWLink IPX/SPX Compatible Transport.

5.Select Properties.

6.Select your (first) network interface card and select Manual Frame Type Detection.

7.Click Add.

8.In the Frame Type field, select Ethernet 802.2.

9.In the Network Number field, type in a unique 8-digit hexadecimal network number. For example: 12345ABC.

10.Select Add.

72