TV-IP522P ProView Megapixel Internet Camera
Reset Camera
A manual reset can be conducted by following the procedure below. The reset button is located on the rear panel of the camera. To reset the system settings to factory defaults, please follow these steps:
1.Leave the camera powered on, do not disconnect the power.
2.Use a paper clip or similar object to press the reset button and hold. The reset button is located on the rear panel of the device. See the Rear Panel Components picture above to locate the reset button.
3.Keep the button pressed about 10 seconds.
4.Release the button.
The camera will then automatically reboot itself. Upon restarting the camera loads the factory default configuration settings. The default IP address 192.168.10.30 and subnet mask 255.255.255.0 will be applied unless a DHCP server is actively connected to the network. The administrator’s default user name is admin and the password is admin. Use the SetupWizard shipped with the camera to reconfigure it or access it through the
13
