TRENDnet TVIP612P manual Reset Camera

TV-IP612P/WN (Wireless N) Pan/Tilt/Zoom Internet Camera

Reset Camera

A manual reset can be conducted by following the procedure below. The reset button is located on the rear panel of the camera. To reset the system settings to factory defaults, please follow these steps:

1.Use a paper clip or similar object to hold down the reset button for three seconds. The reset button is located on the rear panel of the device. See the Rear Panel Components picture above to locate the reset button.

2.Release the reset button and the Power LED will begin to flash, indicating that the Camera is reverting back to factory settings.

Upon restarting the camera loads the factory default configuration settings. The default IP address 192.168.10.30 and subnet mask 255.255.255.0 will be applied unless a DHCP server is actively connected to the network. If using the TV-IP612WN Wireless Camera, the default SSID is “TRENDNet”. The administrator’s default user name is admin and the password is admin. Use the Setup Wizard shipped with the camera to reconfigure it or access it through the web-based management software.

11