Operation
8The EXTERNAL BATTERY TYPE selection screen will appear.
EXTERNAL BATTERY TYPE refers to the ability for the UPS to become aware of which external battery pack is connected to the UPS. Setting the external battery configuration enhances the accuracy of the MINUTES RUNTIME countdown during power failure conditions. The LCD interface supports no external batteries with the factory configuration of BP0. Two additonal LCD configurable external battery pack options are available under the user selection of BP0, BP1 & BP2. See the table to determine whether BP1 or BP2 applies to your external battery pack. If your battery pack is not listed or you are using more than one of any supported external battery pack, you must use Tripp Lite’s EXTERNAL BATTERY CONFIGURATION TOOL software available for download at this link: http://www.tripplite.com/bpconfig
NOTE: Use the BP0 setting if you plan to use the EXTERNAL BATTERY CONFIGURATION TOOL software. After the software configuration is run, the UPS LCD screen will report “BPC”. The UPS can be reset from BPC to BP0, BP1 or BP2 settings via the LCD screen, but once the new configuration is set, you’ll need to run EXTERNAL BATTERY CONFIGURATION TOOL software again to
UPS MODEL | BP0 | BP1 | BP2 | ALL OTHER BATTERY PACK CONFIGURATIONS |
|
|
|
|
|
SU1000XLCD | No BP | Qty 1 BP24V15RT2U | Qty 1 | Use EXTERNAL BATTERY CONFIGURATION TOOL software |
|
|
|
|
|
SU1500XLCD | No BP | Qty 1 | Qty 1 BP48V60RT3U | Use EXTERNAL BATTERY CONFIGURATION TOOL software |
|
|
|
|
|
SU2200XLCD | No BP | Qty 1 | Qty 1 BP48V60RT3U | Use EXTERNAL BATTERY CONFIGURATION TOOL software |
|
|
|
|
|
SU3000XLCD | No BP | Qty 1 | Qty 1 BP72V28RT3U | Use EXTERNAL BATTERY CONFIGURATION TOOL software |
|
|
|
|
|
ACCEPT AND ADVANCE | VIEW ALTERNATE SETTINGS | LEAVE UPS SETUP MODE |
To ACCEPT the current value
&ADVANCE to the next configuration screen, press the ON/SELECT button (less than 1 second).
To VIEW ALTERNATE SETTINGS, press the SETUP BUTTON repeatedly (under 1 second each).
AVAILABLE VALUES
BP0 (factory), BP1, BP2 (BPC reflects a software set configuration)
To leave UPS setup mode, PRESS and HOLD the SETUP BUTTON (about 3 seconds).
9The VIEW IP ADDRESS selection screen will appear.
The VIEW IP ADDRESS is a display field that enables viewing of the current UPS IP address when the SNMPWEBCARD option is in use. The UPS is only capable of displaying a IPv4 level IP address when configured with the SNMPWEBCARD. If VIEW IP ADDRESS is attempted for IPv6 level IP address or for a UPS configuration without the SNMPWEBCARD, the LCD screen will report NA.
ACCEPT AND ADVANCE | VIEW ALTERNATE SETTINGS | LEAVE UPS SETUP MODE |
To ADVANCE to back to the OUTPUT VOLTAGE selection screen, press the ON/SELECT button (less than 1 second).
To VIEW IP address information in 3 digit segments, press the SETUP button repeatedly (less than 1 second).
To leave UPS setup mode, PRESS and HOLD the SETUP BUTTON (about 3 seconds).
24
3/28/2013 1:05:44 PM |
