2.6Installing Chassis Foot Stands

The FT48-B5382 can be used as a standalone device when fitted with the supplied plastic feet. When used as a standal- one device, the feet must be fitted to prevent the unit from falling over.

The four feet should be attached as follows:

1.Each foot consists of two pieces. Insert the round piece of the foot into the larger foot section. The small plastic tab on the round piece should fit into the curved slot on the other piece.

Curved slot

Tab fits in curved slot

2.Use a single screw through the center of the round section to fasten the foot assembly to the bottom of the chassis. The plastic tab that protrudes through the curved slot should fit into an indent in the chassis

case. When fitted, each foot should rotate about 90°.

3.Fit all four feet in the same way.

NOTE: When using as a standalone unit, all four feet should be fitted and extended fully to prevent instability.

40

Chapter 2: Setting Up

Page 48
Image 48
Tyan Computer B5382 manual Installing Chassis Foot Stands