Chapter 2
Board Installation
should use is located at the
Plug in the power connector as shown.
The photos below show the ATX power connector before (Figure 1) and after (Figure 2) it has been plugged in.
warning
Figure 1 | Figure 2 |
The plastic clip on the power connector should lock over the plastic tab on the onboard connector. You shouldn’t be able to plug the power connector in any other way but just to be safe, make sure it looks like Figure 2 above. Make certain that you do not miss any pins because, if you do, you will void your warranty and cause damage to yourself or your motherboard when you turn the system on. After connecting the power, make sure the connector is seated firmly into its socket so it will not become loose or fall off when the computer is jostled or moved. Note: Tyan recommends using an ATX power supply that
conforms to industry standard revision 2.01.
http://www.tyan.com
12
