Active | Passive |
Figure 11 | Figure 12 |
Installing CPU Retention Modules
Installation of a Pentium II processor requires a CPU retention module, which is first secured onto the motherboard.
To attach the retention module, place the motherboard on a flat surface. Locate the key pin on one end of the Pentium II slot on the board. Then carefully line up the key notch on the
retention module with the key pin on the Pentium II slot (the key pin on the Pentium II slot indicates the correct orientation of the CPU).
Drop the retention module (Figure 14 on the following page) down over the Pentium
IIslot so that the retention module sits flat against the motherboard. Tighten the screws in a clockwise manner
to secure the module to the board. Warning: Do not overtighten the screws as you
may damage the module and/or the motherboard.
Installing the Active Processor
When the retention module is securely installed, you are ready to plug in the CPU. Press down firmly on the CPU until you hear a “click” (see Figure 15 ). This
http://www.tyan.com
INSTALL
21
