Chapter 2
Board Installation
(Figure 19) into the pins of the heat sink mounting bracket which are now below the mainboard. There will be a click when the locks are securely fastened.
Removing the CPU.
To remove the CPU, move the locks to the center of |
|
the CPU. A click will be heard when the CPU has | Figure 19 |
been unlocked. Gently pull up on the CPU, taking | |
care not to bend the motherboard or the CPU |
|
retention module. |
|
To remove the lock from the retention module, gently press the ends of the locks inward and pull.
You are done.
Other than checking the jumper settings and cable connections and putting the case back on, you are done. Installing a new motherboard may sound difficult, but by following these directions, you should have a fairly uneventful time installing our products. If you do encounter problems, your dealer will be able to help you, or you can consult one of our many technical support resources (see page 8).
Setting Jumpers
In this manual, the terms “closed” and “on” are used when referring to jumpers (or jumper pins) that are active; “open” and “off” are used when referring to jumpers (or jumper pins) that are inactive. Jumpers and pins are connected by slipping the blue plastic jumper connector overtop of two adjacent jumper pins. The metal rod inside the plastic shell bridges the gap between the two pins, completing the circuit. See the drawings below for examples of “on” and “off” pins and jumpers.
2 pin jumpers | 3 (or more) pin jumpers | |||
off | on | open | ||
1
2
3
1
2
3
1
2
3
http://www.tyan.com
24
