Tyco Electronics P5400 manual Error Messages, Name Tone Description

MM-012099-001, Rev. B

9.4.1Error Messages

If either of the Error Messages shown below is displayed, the radio is programmed incorrectly or needs servicing.

DSP ERR	or	DIG	V	x
ERR=XXXX		ERR		x
(PowerUp
only)

Where: xxxx is the error code and DSP ERR or DIG V ERR is the message.

9.5ALERT TONES

The P5400 radio provides audible Alert Tones or “beeps” to indicate the various operating conditions (see Table 9-2).

	Table 9-2: Alert Tones
NAME	TONE	DESCRIPTION
Call Originate	one short mid-pitched	OK to talk after pressing the push-to-talk
		button
Carrier Control Timer	five high-pitched/one long low-	PTT depressed for maximum length of time
	pitched
Low Battery	one low-pitched/one short mid-	Low battery
	pitched
TX Low Battery Alert	one low-pitched	After PTT - battery too low to transmit

9.6TURNING ON THE RADIO

1.Power ON the radio by rotating the POWER ON-OFF/VOLUME knob clockwise. A short alert signal (if enabled through programming) indicates the radio is ready to use.

2.The display shows the last selected system and group/channel or a default system and group/channel (depending on programming).

3.Adjust the POWER ON-OFF/VOLUME knob to the desired volume level.

4.Select the desired system, group/channel. The display indicates the current system and group/channel names.

5.The radio is now ready to transmit and receive calls.

9.7SYSTEM SELECTION

METHOD 1: From the control knob: If system selection is programmed to the Voice Group Selection control knob, select a system by turning the knob to the desired number position (1-16). The display registers the new system name on line one. The button can be programmed to provide access to a “2nd bank” of 16 system number positions (17-32).

METHOD 2: From the keypad: If system selection is programmed as the primary function of

and , select a system by pressing or to scroll through the system list. The display registers the new system name on line one.

71