Tyco Electronics P5400 manual Call queued for processing

MM-012099-001, Rev. B

10.6 ALERT TONES

The P5400 series radios provide audible Alert Tones or “beeps” to indicate the various operating conditions (see Table 10-4).

Table 10-4: Alert Tones

NAME	TONE	DESCRIPTION
Call Originate	one short mid-pitched	OK to talk after pressing the push-to-talk
		button
Call Queued	one high-pitched	Call queued for processing
Autokey	one mid-pitched	Queued call received channel assignment
System Busy	three low-pitched	System busy or unable to complete call
Call Denied	one low-pitched	Radio is not authorized on the system or
		group
Carrier Control	five high-pitched/one long low-	PTT depressed for maximum length of time
Timer	pitched
Low Battery	one low-pitched/one short mid-	Low battery
	pitched
TX Low Battery	one low-pitched	After PTT - battery too low to transmit
Alert

10.7TURNING ON THE RADIO

1.Power ON the radio by rotating the POWER ON-OFF/VOLUME knob clockwise. A short alert signal (if enabled through programming) indicates the radio is ready to use.

2.The display shows the last selected system and group or a default system and group (depending on programming).

3.Adjust the POWER ON-OFF/VOLUME knob to the desired volume level.

4.Select the desired system and group. The display indicates the current system and group names.

5.The radio is now ready to transmit and receive calls.

10.8SYSTEM SELECTION

METHOD 1: From the Control knob: If system selection is programmed to the Voice Group Selection control knob, select a system by turning the knob to the desired system number position (1-16). The display registers the new

system name on line one. The button can be programmed to provide access to a “2nd bank” of 16 system number positions (17-32).

METHOD 2: From the keypad: If system selection is programmed as the primary function

of and select a system by pressing or to scroll through the system list. The display registers the new system name on line one.

METHOD 3: (P5470 model radios only) Direct Access: Press to enter the system select mode. Press the numeric key, which is mapped to the desired system. Press . The radio will move to the selected system.

90