Uniden BCD996T manual Fire Tone-Out, Setting Tone-Out Standby, Setting Up Tone-Out

Fire Tone-Out

Your scanner can be set to respond to fire tone-outs, a system comprised of standardized two-tone sequential paging, short one-tone paging, and long group tone paging. You can save up to 10 settings. When you select a setting in standby mode, the scanner also monitors for any other setting that uses the same transmit frequency, modulation, and attenuation settings. To quickly switch to Fire Tone-Out mode, press F and then [SQ].

You need tone-out setup information from the agency you wish to monitor. Check with your local agency or on-line resources as Uniden America Corporation has no information regarding local tone-out systems.

Setting Tone-Out Standby

[MENU] J 4 Tone-Out for... JF 4 Tone-Out Standby JF

Turn the Scroll Control 4 to select which of the ten tone-outs to monitor. Or, while holding on any channel, press F then [SQ] to quickly switch to Tone-Out Standby, then rotate scroll to select the settings to monitor. All tone-outs that have the same frequency, modulation, and attenuation setting as the one you select, are also monitored.

In standby mode, the display cycles through all monitored tone-out settings. Regardless of the current display, the scanner always alerts on any received tone-out that matches a stored setting.

If you press [HOLD/RESUME] while in standby mode, the scanner temporarily exits the mode and you hear all transmissions on that frequency. No alerts sound, even if a tone-out matches one you have stored. Press [HOLD/RESUME] again to return to standby mode.

Setting Up Tone-Out

[MENU] J 4 Tone-Out for... JF 4 Tone-Out Setup JF

Scroll to select the tone-out (1 - 10) you want to program, then press F. Then you can scroll to any of the following settings and press F to select and modify the selected settings:

Edit Name — Sets the name for the selected tone-out setting.

Set Frequency — Sets the tone-out’s RF frequency parameters. Then select:

116