Uniden BCD996T manual Setting the Delay Time, Setting the Search Frequency Step, Setting Record

Setting the Delay Time

[MENU] J 4 Srch/CloCall Opt JF

4 Set Delay Time JF

This setting determines how long the scanner waits after a transmission ends before resuming Quick Search or Close Call operation.

1-5 sec — The scanner waits the set amount of time after the transmission ends before resuming. The default setting is 2 sec.

Off — The scanner resumes immediately when the transmission ends.

Setting the Search Frequency Step

[MENU] J 4 Srch/CloCall Opt JF

4 Set Step JF

This setting lets you select the frequency step used during Quick Search and Close Call.

Auto — The step is based on the band (see the table at the front of the manual). This is also the default setting.

5.0 kHz, 6.25kHz,

7.5 kHz,8.33kHz,

10.0 kHz, 12.5 kHz,

15.0 kHz, 20.0 kHz,

25.0 kHz, 50.0 kHz,

100.0 kHz

Setting Record

The scanner uses the selected step.

You can set the REC jack to provide an audio signal to a sound recording device (tape, PC, flash memory) for live recording of transmissions. This also lets you record Quick Search and Close Call transmissions.

[MENU] J 4 Srch/CloCall Opt JF

4 Set Record JF

On — enables an output to an audio recorder at the REC (record output) jack.

Off — disables an audio signal at the output jack.

110