Auto — the scanner uses the default modulation for the channel. The default setting is Auto.

AM — the scanner uses AM (amplitude modulation) for the channel.

FM — the scanner uses FM (frequency modulation) for the channel.

NFM — the scanner uses narrowband FM for the channel.

WFM — the scanner uses wideband FM for the channel.

WFM (Broadcast) — the scanner uses FM Broadcast for the channel.

This setting controls the modulation method used for the channel. In most cases, if you leave this set to Auto, the scanner automatically selects the correct modulation type for the channel you are programming.

Setting Channel Attenuation

C

[MENU] J Program System JF

4Select a conventional system JF

4Edit Group (existing site) JF

4Select a channel group JF

4Edit Channel J F

4Select a channel JF

4Set Attenuator JF

This setting controls whether the scanner attenuates signals on this channel. Select your setting, then press F.

On — the channel is attenuated by about 20 dB.

Off — the channel is not attenuated. The default setting is Off.

You can also toggle this setting by holding on the channel and pressing F then [7] within 2 seconds.

Setting Channel Priority

C

[MENU] J Program System JF

4Select a conventional system JF

4Edit Group JF

4Select a channel group JF

4Edit Channel JF

4Select the channel JF

4Set Priority JF

Programming Your Scanner

89

Page 89
Image 89
Uniden BCD996T manual Setting Channel Attenuation, Setting Channel Priority, Set Priority JF