Programming
Before the UBC3300XLT can begin conventional scanning, you must program a frequency into at least one channel.
Repeat this procedure for each channel you want to program.
Storing Frequencies into Channels in Menu Mode
1.Select frequencies you received from your dealer, from various sources on the internet, or from one of the guides listed on page 11.
2.Press MENU/BACK.
3.Select 2:SCAN OPTION / 1:CONVENTIONAL by rotating the VFO and pressing E.
4.Select a channel.
a.Enter the channel number using the keypad.
b.Then press E.
CH/ |
|
|
FRQ |
|
|
HOLD/ |
| RSM |
MAN |
| |
SCAN | AIR/STEP | SEARCH |
MENU/BACK |
| TRUNK |
L/O
REVERSESELECT
.E
C 001 
1:FREQUENCY
2:DELAY 3:TONE DATA
5. Select 1:FREQUENCY, and press E. a. Enter the frequency number
using . (decimal key) and the keypad.
b. Then press E.
6.Enter the alpha tag and press E. (See page 28.)
7.The following display appears, select the location you want.
C 001
0000.0000 FREQUENCY
C 001 855.0000 FM ALPHA TAG
¡
1:OTHER CHANNEL 2:CHANNEL OPTION 3:DONE
Note: • To clear a mistake while entering the frequency, press . (decimal key) repeatedly until the display is cleared.
26
