Key Beep Option
To choose key beep sound 1:ON or 2:OFF:
1.Press MENU/BACK.
2.Select 3:SYSTEM OPTION / 3:KEY BEEP by rotating the VFO and pressing E.
3.Select 1:ON or 2:OFF by rotating the VFO and pressing E.
Screen Mask
The trunk, frequency, receiving mode, and signal meter indications on the display are masked when this feature is activated (except while in Search mode). This feature reduces the amount of displayed information.
Note: While Screen Mask is ON, Enter Lock is active.
1.Press MENU/BACK.
2.Select 3:SYSTEM OPTION / 2:SCREEN MASK by rotating the VFO and pressing E.
3.Select 1:ON or 2:OFF by rotating the VFO and pressing E.
Reverse Mode
This key will allow you to observe the reverse frequency of the repeater. While pressing REVERSE, the standard pair frequency will be displayed. For a list of the standard pair frequencies, refer to the table “Reverse List” in the Appendix. If the frequency that you have chosen does not have an offset frequency, the display will indicate ERROR and NO REVERSE.
Channel Step Selection
You can set channel steps, 5 kHz - 100 kHz or Auto, in Conventional mode or Chain Search mode. The default receive mode should be the proper mode setting in almost all cases. You may wish to set some VHF channels for NFM mode, depending on any adjacent channel interference problems. WFM is typically only used for broadcast frequencies such as TV audio or FM radio.
See STEPS in "Menu Description" for details.
77
