3.Select the channel number by rotating the VFO and pressing E. You can also enter the channel number by using the keypad and then press E.
4. Select 1:FREQUENCY and | C 001 | |
ALPHA TAG by rotating the VFO | 855.0000 | FM |
and pressing E. | ALPHA TAG |
|
Note: You can only assign a text tag to | ¡ |
|
|
| |
the channel where the frequency is stored. |
| |
5.The cursor appears on the display. Rotate the VFO to change letters, and press HOLD/MAN or RSM to move right or left. Both capital and lower case letters are available, as well as numbers and punctuation marks.
6.After entering the desired text, press E.
☞Remember! To clear a mistake while entering the letters, press HOLD/MAN, RSM or . (decimal key) repeatedly until the display is cleared.
Beep Alert
The scanner can alert you with three beeps at the beginning of a transmission on an assigned frequency.
Assigning the Beep Alert to a Channel
This alert can be set ON/OFF for every channel in Conventional mode.
In conventional mode -
1.Press MENU/BACK.
2.Select 2:SCAN OPTION / 1:CONVENTIONAL by rotating the VFO and pressing E.
3.Select the channel number by rotating the VFO and then pressing E. (You can also enter the channel number by using the keypad and then press E.)
4.Select 4:BEEP ALERT by rotating the VFO and pressing E.
5.Select 1:ON or 2:OFF by rotating the VFO and pressing E.
Note: If NOT REGISTERED appears, make sure a frequency is stored in the channel.
29
