Uniden UBC3300XLT manual To connect the Scanner to Scanner

To connect the Scanner to Scanner:

Plug the smaller end of each of the		Null Modem Adapter
			Pin connections
(Optional) Remote Interface Cables into
			Female	Male
the remote ports in accordance with the
			DB9	DB9
direction of the	marks which are on the		1	4
			2	3
right sides of each of the two scanners.
			3	2
			4	6 & 1
Plug the other ends of the cables (DB-9			5	5
			6	4
serial connector) together using a DB-9 to			7	8
			8	7
DB-9 null modem adapter, and a Gender
			9	Not used

Changer Cable available at most computer stores.

CH/			CH/
FRQ			FRQ
HOLD/		RSM	HOLD/		RSM
MAN			MAN
SCAN	AIR/STEP	SEARCH	SCAN	AIR/STEP	SEARCH
MENU/BACK		TRUNK	MENU/BACK		TRUNK
L/O			L/O
REVERSE		SELECT	REVERSE		SELECT
.		E	.		E

You can clone all of the programming of one UBC3300XLT into another, including frequencies, talkgroup IDs, alpha tags, delay settings, etc. After connecting the two scanners,

turn the radios ON. Prepare each scanner for clone mode as follows.

1.Press MENU/BACK.

2.Select 3:SYSTEM OPTION / 6:CLONE by rotating the VFO and pressing E.

3.Determine the scanner that has the frequency data that you want to transfer. This one must be set up as the "Master Unit", and the other must be set as the "Slave Unit".

4.On the scanner that is the "Master Unit", select MASTER, then press E.

5.On the scanner that is the "Slave Unit", select SLAVE, then press E.

CLONE SELECT UNIT

MASTER

SLAVE

CLONE SELECT UNIT MASTER SLAVE

74