6.Press SEARCH to start auto storing.
7.After the search has gone through the search range, press HOLD/MAN to stop this feature. STORE END appears on the display. You may want to let it run through the search range several times because during the first pass there may not have been any transmissions at that particular time on that frequency.
C 001
1245.8500 FM Bank 12--56----
AUTO STORE
Squelch (SQ) Mode
The scanner can be set to the following SQ modes.
•Carrier SQ mode (default setting)
The scanner will stop on any transmission or squelch opening, regardless of whether any subaudible tone has been programmed for the channel or search range.
•Tone SQ mode
The scanner will stop on any active frequency for which either no subaudible tone has been programmed or for which the
•Tone Search mode
During any transmission, the scanner will begin searching all possible subaudible tones, one of which may also be in use. The scanner counts up through the CTCSS tones and instantly determines any possible DCS tone. See page 90 for a listing of the tones that the UBC3300XLT decodes.
Note: When Tone Search is active in Scan mode, once the CTCSS or DCS display flashes a tone repeatedly (meaning that it has found the tone match), you can press E to program that frequency with the captured tone. When you change the mode to Tone SQ from Tone Search that frequency and tone will be programmed.
•Tone Lock (out) mode
For either a Memory channel or a Search Range, you can lock a particular subaudible tone by pressing L/O after scrolling to the desired tone. The scanner will stop on any transmission except those which may be using the locked subaudible tone.
To set your scanner, enter into the Menu mode.
1.Press MENU/BACK.
2.Select 3:SYSTEM OPTION / 8:SQ MODE by rotating the VFO and pressing E.
40
