Installing the Repeater/Charger(s) (if included)
Connect the repeater/charger power cord
1. If your phone came with any accessory handsets and chargers, connect a charger AC adapter to each charger's DC IN 9V jack and set the plug into the notch as shown. (These adapters might already be connected.)
2.Plug the other end of the adapter into a standard 240V AC power outlet.
Attach the stand
3.To attach the stand, you have to decide if you want the repeater to rest on a desk or hang on a wall.
For desktop use, turn the stand so the locking tabs that say DESK are facing the base with the arrows pointing up.
OR
For wall mount use, turn the stand so the locking tabs that say wall are facing the base with the arrows pointing down.
4.Align the stand with the notches on the repeater.
5.Slide the stand onto the notches until it clicks into place. (To remove the stand, pull the locking tabs up and back. Then, slide the stand straight off the same direction you put it on.)
Place the repeater/charger on the wall
6.For wall mount use, place the mounting slots (hole spacing is 30mm horizontal) over the pins on the wall, and slide the base down to lock it into place.
To place a Repeater/Charger
xx
xx
Make sure you have a strong signal from the base (at least 3 bars in the handset display).
Put the charger at least 10m away from the base or any other Repeater/Charger. (If you put the charger on a different floor from the base, don't forget to allow 10m vertically, also.)
5
