Charging the Lithium-Ion Battery Pack | Unitech PA967, PA966

PA966/967 User's Manual

Chapter 3. Power System

Charging the Lithium-Ion Battery Pack

The optional Docking Station is a convenient accessory for daily use of the PA966. Charging the battery pack using the Docking Station takes approximately 3 hours.

Or, when using the included Charging/USB cable or Charging/ RS232 cable, the charging time of the battery pack is also about 3 hours.

Charging the Main and Backup Battery for the First Time

Note: Before using the PA966 for the first time, charge the unit for 16 hours to fully charge the empty backup battery. Operating the PA966 for the first time without the AC adapter, and without fully charging the backup battery may result in loss of data stored in RAM memory.

Note: Backing-up data by backup battery only, without the main battery installed in the battery compartment, may take as long as 4 hours. Therefore, in order to prevent data protection failure due to backup battery failure, do not leave the PA966 without the rechargeable battery pack installed, or without connection to AC power for an extended period of time.

It may take up to 96 hours to backup data when the PA966 is automatically shut down because of very low battery power while the depleted batteries are still installed in the battery compartment.

24

Image 28

Unitech PA967, PA966 Charging the Lithium-Ion Battery Pack, Charging the Main and Backup Battery for the First Time

Contents

PA966 / PA967 Portable Terminal Page Page Page Introduction Unitech PA966 & Accessories Tour of the Unitech PA966 Installing the Battery Pack First Steps with the Unitech PA966 Supplying Power to the PA966 Charging the Main and Backup Batteries for the First Time Protective Screen Film Using the StylusFirst Operation of the Unitech PA966 Setting Time Zone, Date, and Time Setting the Time Zone firstSetting the Year and Month Exiting Date/Time Properties Settings Flash Memory Keypad Alpha Keypad Layout Useful Hotkeys Software Keyboard Windows CE Keyboard Modifying the Scanner Settings Using the Built-in ScannerScan2Key Bar Code Symbologies 2D Symbologies Data OptionsPrefix Suffix Proximity Reading Options Scanning OptionsReplace Suffix with Carriage Return Transmit Function Code Power Management Options Timeout To SleepImager Idle Timeout Imaging Options Power On Delay Re-Open Scanner Port After Resume PowerEnable Log scanner.txt Miscellaneous Options Show Data Only 1D ScanningAuto-Scan Reset Sequence Number Show Sequence Number Save To File Clear Window Enable Scan 2D Scanning Save Image Image ScanningScan2Key Version Charging the Lithium-Ion Battery Pack Charging the Main and Backup Battery for the First Time Power Status Indication Checking Main and Backup Battery Status How to Save Battery PowerEnter Power Properties Check Battery Status Backlight Setting Warm Boot / Cold BootAutomatically turn on the backlight when any key is pressed Warm Boot Cold Boot Storage and Safety PrecautionsCharging Considerations Connecting IntroductionSerial or USB Cable Docking Station Installation ActiveSyncPage Page Using the Mobile Devices Window Mobile Devices Features Changing Communications Settings Synchronization To turn on IrDA Files What Gets SynchronizedChanging Synchronization Options InBox Installing and Removing SoftwareSending and Receiving E-Mail with InBox Sending Mail Remotely Setting Up Remote MailWork Remotely Receiving Messages Sending Messages Wireless Communication Bluetooth Setup Bluetooth ActiveSync Page OS and Software Programming Tools CPU / MemoryMechanical / Environmental Interface Port PowerInput / Output 1D Scan Engine 2D Scanner Symbologies 1D Scanner Symbologies2D Scan Engine Pin Assignment for Charge / Communication Port Docking Station Perform a cold boot Warning Terminal will be reset to Factory default settings and data will be lost Canadian Compliance Statement FCC StatementEuropean Conformity Statement Unitech America