Universal Laser Systems X-600, X2-600 manual Leveling the System

Installation 2-7

Leveling the System

1. If the floor underneath the

Laser System is uneven, the

casters

must

be

adjusted.

Place a bubble level across the

top of the legs directly above

the front casters. Note the

bubble position in its sight

glass. Do the same for the

back part of the legs and also

note the position of the bubble

in the sight glass. If the bubbles

are in the same visual position,

adjustment

is

not necessary

and cart assembly is complete.

If they are in different positions,

adjustment is required.

2. To adjust the casters, choose

ONLY ONE (1) caster and

adjust its height until both

bubbles

are

visually

identical

between the front casters and

L

E

V

E

the back casters. The purpose

EL

L

B

B

of this step is to make sure that

U

B

all casters lie in the same

plane, not to level the laser

system with the ground. If

desired, you can level the laser

system

with

the

ground

although it is not required.

3.Open the top door and remove the rubber band that is holding the arm in place.

4.If you haven’t already done so, remove any remaining packing materials, accessories or any other items that may be located inside the cabinet or on top of the engraving table.

5.Gain access to the rear of the laser system to install the Laser Cartridge.

Laser Cartridge Installation

Before connecting and powering on your system, you must install the Laser Cartridge(s). Make sure that your power cord IS NOT plugged in at this time.

The following procedure is for both the X-600 and the X2-600 Platforms. The difference is that the X2- 600 can accommodate one or two Laser Cartridges. No matter which system you have, if you only have one Laser Cartridge, install it in the TOP position.