|
| Sample Materials |
|
| COMMENTS |
|
| The laser system can be used to make dies for |
|
| seal presses. It can engrave and cut out a |
|
| typical Notary Seal in less than 5 minutes. |
|
| Create the male with a white graphic and a black |
|
| background. Mirror the image and invert it by |
|
| making the background white and the graphic |
|
| black. Add a .010 inch black outline to the |
|
| graphic portion of the female side. This will give |
|
| the greater clearance to the female side to |
MALE | FEMALE | prevent the paper from piercing through when |
the male side of the seal presses into the female | ||
|
| side. Once the seal is made and fastened to the |
press, make several impressions onto 400 grit sandpaper to smoothen out the edges of the plastic. Make sure you turn the sandpaper over to get both sides of the seal.
LASER CUTTING THIS MATERIAL CAN CAUSE FLAMING. Use caution when attempting to cut this material. Make sure that the flame does not come in contact with any part of the laser system. NEVER leave the machine unattended while processing any material. Damages caused by processing any material WILL NOT be covered under warranty.
