Installation of Logs
The logs are fragile and should be handled with care. Keep the packaging material out of the reach of children and dispose of the mterial in a safe manner.
The individual logs can be easily identified by the numbers cast on the underside of each log.
1.Remove the top louvre assembly.
2.Open the bottom louvre.
3.Remove the window frame assembly.
4.Remove log box from inside firebox.
5.Unpack the logs from packaging and remove each log from its wrapping material. Set aside the ember and the lava rock bags.
As with all plastic bags - these are not toys and should be kept away from children and infants.
XDV Direct Vent Gas Fireplace
Log Identification Chart
LOGS | 33XDV | 36XDV | 39XDV |
Log Rear | A49 | B152 | 20010994 |
Log Center Right | A51 | B153 | |
Log Right Top | A52 | B154 | 20010995 |
Log Front | A50 | B155 | |
Log Cross Over Center | A53 | B156 | |
Log Left Top | A54 | B157 | |
Log Top Center | 20010677 | ||
Log Front Right | 20010672 | ||
Log Front Left | 20010996 | ||
Log Overlay | 20010674 |
33XDV
1.Place ember material on top of front burner. Separate the ember material into small pieces approximately 1/2” in diameter and keep 1/2” space between the ember pieces. (Fig. 50)
2.Place the log rear (A49) over the rear log bracket. Align the underside hole on the left to sit over the pin stud pointing up on the rear log bracket. Push the right side of the log against the back. (Fig. 50)
Figure 51
Log Center Right (A51)
Figure 50
Log Rear (A49)
LG954
Ember Material
3.Place the log center right (A51). Place the two underside holes of the log over the two pin studs of the bracket on the right side of the burner housing. (Fig. 51)
LG955
10009383 | 25 |
