XDV Direct Vent Gas Fireplace
4.Place the log front (A50). Place the two underside holes of the log over the two pin studs of the bracket located at the front of the burner housing. (Fig. 52)
5.Place the log top right (A52). Place the bot- tom round hole onto the knob at the right side of the rear log. The cross section of the log will rest on top of the center right log. (Fig. 53)
6.Position the log cross over center (A53) by locating the bottom rectangular slot of this log onto the knob at the center of the front log. The other end of the log, with the bottom round hole, will be on the knob located on the top center of the rear log. (Fig. 53)
LG956
Figure 52
Figure 53 | Log Left Top |
|
| (A54) | Log Cross Over |
Log Rear |
| Center (A53) |
(A49) |
|
|
Log Top Right (A52)
Log Center Right (A51)
Log Front (A50)
7.Place the log left top (A54). Place the bottom rectangular slot of this log onto the knob at the left side of the front log. (Fig. 53)
8.Place large lava rock onto the two sides of the burner tray as shown in Figure 53.
Do not place any of the lava rock material on the burner housing assem- bly.
LG958
| Log Front (A50) |
Lava Rock | Lava Rock |
| |
| Ember Material |
36XDV
Figure 54 | Log Rear |
(B152) |
1.Place the log rear (B152). Place the two underside holes of the log over the two pins studs of the rear log bracket. (Fig. 54)
LG948
Ember Material
26 | 10009383 |
