Videk 2030 manual Removing and Attaching Handle

1.11 - Removing and Attaching Handle

The battery-handle must be attached to the VisionSensor 2030 for proper operation.

The battery automatically charges every time the USB interface is attached to the VisionSensor 2030 and the host PC is powered up.

Attaching the Battery Handle

Step 1: Begin assembly by inserting the tab at the back of the handle into the reader’s battery compartment.

Step 2: Push the reader forward snugly against the handle.

Step 3: Snap the reader to the handle. Assembly is complete.

Note: To further secure the reader to the handle use the two screws included in shipment (optional). The screws are located on the underside of the reader.

Removing Reader from Handle

First remove the two screws (if used) from the underside of the handle. Next, release the battery compartment clip as shown, then remove the reader from the handle.

An optional battery charger cradle is available.

Please contact Videk for additional information.

Save Settings K11020 VisionSensor™ 2030 User Manual, Rev. E, Software ver. 3.1.1000, August 3, 2007 - 17